MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019 Page 77
Appendix A: Epson TM-M30 Programming
7 Program one of the two IP Addresses found in the following form into the correct sections of
the Epson TCP/IP programming screen.
Note: The IP address used will/should reflect what CWS it is tied two. Ensure that the
acquired IP address is set to manual and all other settings are set as shown in
Figure 111.
Figure 111: Network Configuration
Receipt Printer Number Main IP Address Subnet Mask Default Gateway
Receipt Printer One 10.5.61.52 255.255.254.0 10.5.60.1
Receipt Printer Two 10.5.61.53 255.255.254.0 10.5.60.1
Configuration of the Receipt Printer(s) is done using a routing device with the EpsonNet
Configuration Tool loaded onto a laptop PC.
IMPORTANT INFORMATION
8 Once the IP Address information is entered, click Send. Press Reset once it is displayed on
screen.
To configure the receipt printer using a routing devi
ce with the EpsonNet Configuration Tool,
proceed as follows:
1 Ensure that the EpsonNet Config Tool is downloaded on your laptop.
Note: This tool can be downloaded from Epson’s support web page.
2 Ensure that the Epson Ethernet printer is plugged into the network that can provide IP address
(DHCP should be turned on) and is turned ON.
3 Configure your laptop to work within the network and ensure that you can “ping” the router.
4 The Epson Ethernet printer should have an IP address from the network and it should be
printed.
To Next Page
Loading...
Need help?
General