Gilera DNA - Clock; Digital Lcd Display; Setting the Total and Trip Odometers

Clock
The time is displayed even when the engine is off (as the clock is powered directly by
the vehicle's battery); it is displayed in a 12-hour mode with "AM" or "PM" subscripts.
To adjust the time, proceed as follows: press the "MODE" button until the time is dis-
played, hold down the "CLOCK" button for more than 3 seconds; the hour digit will
now start blinking, and may be set by pressing the "SET" button. To set the minute
digits, press the "CLOCK" button for less than 1 second and adjust through the
"SET" button. Pressing the "CLOCK" button at this stage will update the time and
switch the display back to clock mode.
CAUTION
WE STRONGLY RECOMMEND YOU REFRAIN FROM USING THE LCD FUNC-
TIONS WHILE RIDING
Digital lcd display
The "MODE" button allows you to switch between the trip odometer and the clock. It
operates as follows: if held down for less than 1 second, the trip odometer is displayed;
when pressed again for less than 1 second, the digital clock is visualised, and pressing
the button again for less than 1 second will bring back the total odometer reading. To
zero the trip odometer, hold down the "SET" button for more than 3 seconds when the
trip function is displayed.
Setting the total and trip odometers
Pushing the "MODE" button for less than a second obtains, respectively, the functions
of:
1. TOTAL - The word "TOTAL" appears and Km/h or mph. The value corre-
sponds to the total distance travelled by the vehicle and it is not adjustable.
10
1 Vehicle