EasyManua.ls Logo

Gilera DNA - Starting the Engine

Gilera DNA
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
02_05
Starting up the engine (02_05)
The engine is fitted with an automatic continuously variable transmission (CVT) and
clutch. For this reason, the throttle must not be twisted when the engine is being star-
ted; to pull away, progressively increase the throttle opening. The vehicle is also
equipped with a vacuum fuel tap and an electric choke device which are automatically
engaged when the engine is running. In order to start the engine, pull the right, "F", or
left hand-side brake lever, "B", while pressing the engine starter button, "A", as this
will disengage the starter safety switch.
1. Rest the vehicle on its centre-stand, "D", ensuring the rear wheel is not touching
the ground.
2. Maintain the throttle twist-grip in the idle position.
3. Insert the key into the ignition key-switch and turn it onto the «ON» position; as the
key is turned, the low-oil and fuel warning lights go on for a few seconds, confirming
the correct operation of the bulb and circuit for the low-oil warning light, and of the light
bulb only for the low-fuel warning light.
4. Ensure the engine cut-off switch, «I», is set onto the «RUN» position and the side-
stand, «L», is retracted.
CAUTION
DO NOT CARRY OUT THESE OPERATIONS IN CLOSED AREAS SINCE EX-
HAUST GASES ARE TOXIC.
CAUTION
DUE TO THE HIGH TEMPERATURES THE CATALYTIC CONVERTER CAN
REACH, ALWAYS TAKE CARE, WHEN PARKING THE SCOOTER, THAT THE
EXHAUST DOES NOT COME INTO CONTACT WITH FLAMMABLE MATERIALS,
TO AVOID SERIOUS BURNS.
21
2 Use

Related product manuals