Gilera DNA - Setting the Hour;Minutes Function

2. PARTIAL- The word "TRIP" appears and Km/h or mph. The value can be
changed by pressing and holding the "SET" button for longer than three sec-
onds.
N.B.
IT IS POSSIBLE TO CHANGE THE DISPLAY FROM KILOMETRES (km/h) TO
MILES (mph) BY PRESSING THE "MODE" AND "CLOCK" BUTTONS AT THE
SAME TIME AND HOLDING THEM FOR LONGER THAN THREE SECONDS AF-
TER PUTTING THE KEY SWITCH IN THE «ON» POSITION.
ON THE DISPLAY THE WORD "SET" WILL APPEAR FOR ONE SECOND
CAUTION
IT IS STRONGLY ADVISED NOT TO USE THE FUNCTIONS OF THE DIGITAL
DISPLAY PANEL WHILE THE VEHICLE IS MOVING.
Setting the hour/minutes function
To set the clock, hold down the «CLOCK» button for more than three seconds. The
numbers representing the hours will start blinking.
Set the hours using the «SET» button.
By pressing the «CLOCK» button again the numbers representing the minutes will
start blinking.
Set the minutes using the «SET» button.
Press the «CLOCK» button again to exit the setting mode.
The setting mode is terminated automatically if, during the setting, no button is pressed
for a period longer than 8 seconds, and the last set time will be shown on the display.
11
1 Vehicle