EasyManua.ls Logo

Gilera Runner 125 - Spark Plug Dismantlement

Gilera Runner 125
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rear tyre Tubeless, 140/60 - 13'' 63P
TYRE INFLATION PRESSURE
Front tyre pressure 1.8 bar
Rear tyre pressure 2.2 bar
03_09
03_10
Spark plug dismantlement (03_09, 03_10, 03_11)
Remove one of the two sides of the footrest, unscrewing the four fastening screws,
one of which is under the passenger footrest.
Detach the spark plug shielded cap and remove the plug with the box-spanner sup-
plied.
To reinstall it, screw in the spark plug by hand, setting it at the necessary angle; Use
the wrench only to fasten it. Carefully reinsert the screening hood.
When refitting, use caution while inserting the passenger footrest in its hole in side-
panel, then tighten the four screws manually.
CAUTION
FOLLOW THESE PROCEDURES VERY CAREFULLY TO AVOID ANY SEVERE
DAMAGE THAT MAY BE CAUSED BY THE VERY POWERFUL IGNITION SYS-
TEM.
41
3 Maintenance

Related product manuals