EasyManua.ls Logo

Gilera Runner 125 - Rear Optical Unit

Gilera Runner 125
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
03_33
03_34
03_35
Rear optical unit (03_33, 03_34, 03_35, 03_36)
To access the rear taillight bulbs, remove the two screws «A», then pull out the entire
light and proceed as follows:
Daylight running light bulbs (side):
Both the bulbholders and the daylight running lights «B» are clipped on the their re-
spective supports, it is therefore sufficient to remove the bulbholder from the head-
lamp, remove the bulb, and replace it with a new one.
Stop light bulbs(centre):
In order to access the stop lights it is necessary to remove the rear light by unscrewing
the four fixing screws «C» on the transparent headlamp support, then rotate the burnt
bulb 30° in an anticlockwise direction, remove it and replace it.
WARNING
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
TO LOW TEMPERATURES.
THE PHENOMENON SHOULD QUICKLY DISAPPEAR WHEN THE LIGHT IS
SWITCHED ON.
56
3 Maintenance

Related product manuals