Gill Instruments 1360-PK-022 User Manual

Gill Instruments Ltd
Intrinsically Safe WindObserver Anemometer Page 40 Issue 10
Doc. No. 1360-PS-0001 May 2015
9. ANEMOMETER SOFTWARE COMMANDS
The Intrinsically Safe WindObserver can be configured using Terminal emulator
software such as HyperTerminal.
Alternatively it is possible to use Gill Wind Software as a Terminal program only
(Wizard and Sync Comms not applicable). Wind will run on PC’s up to and including
Windows 8 and can be downloaded from:-
http://www.gillinstruments.com/main/software.html.
9.1 Configuring using HyperTerminal
Note – Other terminal emulators are configured in a very similar way.
1. Check the PC Hardware settings to find which Com port that the unit is connected to.
2. Open HyperTerminal.
3. Create a New Connection (File  New Connection).
4. Enter a Name (eg TEST) and click on OK.
5. On the next screen use drop down menu for ‘Connect using’, select COM 1 Port (for
a PC RS232 serial port connection to a 9 way D Type connector) or applicable COM
port. Click on OK.

Gill Instruments 1360-PK-022 Specifications

General

Brand	Gill Instruments
Model	1360-PK-022
Category	Measuring Instruments
Language	English