WindSonic Doc No 1405 PS 0019 Issue 28 November 2019
3
9.7.10 Error condition reporting 36
10 CONFIGURING 39
10.1 WIND 39
10.2 WINDVIEW 43
10.3 CONFIGURING USING HYPERTERMINAL 48
10.4 ENTERING CONFIGURATION MODE 48
10.5 RETURNING TO MEASUREMENT MODE 48
10.6 CHECKING THE CONFIGURATION 49
10.7 CHANGING A SETTING 49
10.7.1 Command List 50
Bx - Baud rate 51
Cx - Analogue settings 51
Dx - Diagnostic and Configuration Command (See Section 10.8) 51
Ex - Communications Protocol 51
Fx - Data and parity options 52
Gx - (To be allocated for future developments) 52
Hx - Power-up Message 52
Kxx to Kxxxx - Minimum Direction Velocity 53
Lx - Message Terminator 53
Mx to Mxx - Message Format 53
Nx - Node Address 53
Ox - ASCII Output Format 54
Px to Pxx - Output Rate 54
Q - Measurement Mode 54
Sx - Analogue Output Range 55
Tx - Analogue Output Type (Voltage or Current) 55
Ux - Output Units 55
Yx – Analogue Output, Error Status Condition 55
10.8 CONFIGURATION / DIAGNOSTIC INFORMATION 56
11 MAINTENANCE & FAULT-FINDING 57
11.1 CLEANING 57
11.2 SERVICING 57
11.3 FAULT FINDING 57
11.4 RETURNING UNIT 58
11.5 STATUS 58
12 TESTS 58
12.1 BENCH TEST 58
12.2 SELF-TEST (STILL AIR) 59
12.3 USING SAFE MODE TO GET COMMUNICATION AND TO CHANGE SETTINGS 60
12.4 CALIBRATION 61
13 APPENDICES 62
13.1 GLOSSARY & ABBREVIATIONS 62
13.2 GUARANTEE 62
13.3 WINDSONIC OPTIONS 1, 2, 3 AND 4 63
ELECTRICAL CONFORMITY 63
14 SDI-12 WindSonic 64
14.1 WINDSONIC OPTION 4 SPECIFICATION 64
14.2 CABLE TYPE 65
To Next Page
Loading...