------------------------------------------------------------- Auto Ref/Keratometer GRK-7000
39
8.1.2. Auto Measurement Mode
As pushing Auto button in Manual Measurement mode, it automatically changes
to the Auto measurement mode.
– As the condition of good array between the machine and the measured eye is
reached, the measurement is to be performed automatically without pushing th
e measure button.
① Perform the ①, ② procedure of manual measurement mode.
② Measurement
- As the array and adjusting the focus is completed, the measurement is to
be performed automatically.
- After the measurement of times (3 or 5 times) designated in user Setup
mode is performed, the measured result appear on the screen of monitor.
- Maximum of 10 units of data is to be stored, and you can re-check them
in DISPLAY mode.
[ Figure 18-1. Screen indicating Auto Measurement Mode(AUTO-
3)]
To Next Page