21
Damper Settings
Bump: To set the bump on the damper, firstly wind the adjuster on the damper canister towards the housing, feeling
the clicks as this is completed. When a noticeably bigger click is felt and it stops moving, the damper is at full stiff.
This is the starting point to set bump, now wind the adjuster in the opposite direction one click at a time, until the
required setting is reached.
Rebound: Setting the rebound is much the same. Start by winding the adjuster on the damper body towards the top
of the damper until it stops, this is now at full stiff. Then wind the adjuster back out, counting the clicks to the
required setting.
Damper Graphs