Air Jack / Gas Bottle Regulator
Once the gas bottle has been connected to the car via the air lance, you are ready to raise the G55 off the ground.
In order to fully extend the air jacks, the regulator needs to be set to 34 bar of pressure, as indicated by the red
arrow in figure 1.4.
It is very important that you DO NOT exceed 40 bar of pressure as
this can cause damage to the air jack system.
The fittings and regulator can be supplied by CES Europe Ltd.
(www.ceseuropeltd.co.uk / 01295 279558).
ECU Download Lead
In order to download data from the car, you will need a download lead.
For cars with an M150 ECU, an Ethernet cable is supplied with the car along with the Motec software required to
download data directly to your laptop.
For cars with the M800 ECU, a UTC download lead is needed. This can be purchased directly from Ginetta.
(www.ginetta.com / 0113 385 4164).
Dump Churn
The standard Ginetta G55 comes with a dry brake filler only.
Therefore, a dump churn is an essential piece of equipment which
will be used for quick and easy refuelling of the car.
To Next Page
Loading...
Need help?
General