Generally, 8 MB storage capacity is required in an hour.)
5) G30 starts to search for satellite and the satellite lights start flashing. When the recording
condition is reached, the status light will flash at the set sampling interval, and the flash
indicates that an epoch is collected.
6) After the surveying finished, shut down G30, and then transport the data and process data.
§ 3.2 RTK Mode（External Radio）
§3.2.1 Base Setup
Base station must be set up in the open field, the surrounding environment should be open,
the terrain should be higher. Do not set it up near high-voltage power transmission, transformation
equipment, near radio communication equipment antenna, or under trees and near water.
Setting steps:
1) Set up the tripod as shown in the figure above, hang up the radio, fix the G30, and connect
the extension rod and the large radio transmitting antenna.
2) Connect G30 by 5-pin data transmission cable with external radio. Connect the battery with
Radio by Y-type power cable.
To Next Page
Loading...
