Chapter IV: WEB UI
§4.1 WebUI Login
Start the G30 properly, use a mobile terminal such as a laptop or mobile phone, open wifi,
and find the G30’s hotspot. The hotspot name format is “GINTEC_XXXX”(GINTEC_3260).
After connecting successfully, enter 192.168.10.1 in the browser and go to the WebUI
background page.
§4.2 Common Function from WEB UI
§4.2.1 Code Registering
Clip “Configuration-General Config”, you can paster the register code here to active the
G30. Function codes such as PPP activation codes are also registered here.
To Next Page
Loading...
