2) Under “Base Mode Settings”, Choose “Data link” to be “Internal Radio”, set the channel,
frequency and protocol, then apply to finish setting.
§3.3.3 Rover Setup
This step is the same as §3.2.3 Rover Set up, please check this section.
§3.4 RTK Mode（Network mode）
§3.4.1 Base Setup
Base station must be set up in the open field, the surrounding environment should be open,
the terrain should be higher. Do not set it up near high-voltage power transmission, transformation
equipment, near radio communication equipment antenna, or under trees and near water.
Set up the tripod as shown in the figure above, fix the G30, and connect the radio antenna.
§3.4.2 Starting Base
1) After setting, please make sure there is a workable Sim card inside G30 base. Then open
SurPad in the controller, Click “Device”→ “Base” to set Base station.
To Next Page
Loading...
