§3.2.3 Rover Setup
After successful set up of the base station, now we can start the rover setting.
Install the G30 on the centering lever, install the radio antenna, bracket, clamp the controller.
The steps are as follows:
1) Turn on the G30 and controller, open SurPad software and connect Bluetooth.
2) Clip “Device” - “Rover”, choose “Data link” as “Internal Radio”, and choose the same
channel and protocol as Base. Clip “Apply” to start rover.
3) When it shows “Fixed”, it is correctly setting, now you can start the surveying work.
To Next Page
Loading...
