2) Under “Base Mode Settings”, Choose “Data link” to be “Device Internet”, then go to set
Cors parameter. (When use “Device Internet”, please input the correct the APN setting as
your mobile network service provider ask for)
3) Clip “Add” in the Cors setting page, then import your Cors “IP” and “Port”, then choose the
Cors information you set, clip “OK”.
4) Input the name you want in “Bae access point”, and you can also input “password” , then
apply. (Remember what you have input, it will be useful when you set up rover).
§3.4.3 Rover Setup
After successful set up of the base station, now we can start the rover setting.
Install the G30 on the centering lever, install the radio antenna, bracket, clamp the controller.
The steps are as follows:
1） Turn on the G30 and controller, open SurPad software and connect Bluetooth.
To Next Page
Loading...
