removed. This function is the safest and most easily achieved with four
people. Carefully slide the new fabric into the lead rail and roller tube
simultaneously. Two people can pull the fabric through the channels
while two others support the excess fabric and feed the fabric into the
lead rail and roller tube.
3.
Center the fabric on the roller tube and then smooth all of the wrinkles
out at the lead rail. Insert a self tapping screw into the roller tube on
the side opposite the motor location. The fabric will center itself on the
lead rail. (Figure 16)
4.
Using the manual crank, slowly begin rolling the fabric onto the roller
tube. Roll the fabric from the bottom of the roller tube.
5.
Start retracting the awning using the remote control or the wall switch.
Using two people carefully stretch the fabric from end to end during
the first couple of revolutions of the roller tube. This will ensure that
the fabric is rolling onto the tube straight. Continue to slowly roll the
fabric onto the tube until the fabric is taut against the lead rail.
Continue to roll the fabric onto the tube. Make sure the fabric rolls
straight and the awning closes completely.
6. Open the awning about 18” and replace both fabric set screws on the lead rail.
!
To Next Page
Loading...
