Page 11SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
MENU BAR
The Menu Bar is listed at the top left of the Configuration Software
program window. It contains three useful drop-down menus to navigate
various functions of the program. The following paragraphs explain the
functions included in the Menu Bar.
FILE MENU
• New Configuration - This will reset the values for all
configurable parameters to default. Standard Messaging
without Motion with a transmission every 12 hours is the
default Mode of operation.
• This selection opens a prompt window asking for
confirmation to restore all settings to their default. This
will not affect the settings stored inside the connected
SmartOne(s). The settings will only reset in the software display. The PROGRAM button must be clicked to
download the configuration to any connected devices.
• Open Configuration from File. This opens a window
allowing the user to browse for a valid configuration
file that has previously been saved. Selecting a file will
cause the settings contained in the file to be loaded
into the software display only. The PROGRAM button
must be clicked to download the configuration to any
connected devices.
• Read Configuration from SmartOne. This will
query the configurable parameters saved in a
device connected to the PC. The values for each
configurable parameter in the device will be
displayed in the User Data Entry Pane.
To Next Page
Loading...
Need help?
General