Page 34SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
UNDESIRED STATE MESSAGE
• Input 1/Input 2 - The SmartOne can be configured to send messages throughout the time the input is in the
undesired state, either to the Open or Closed position. The message interval while the input is active can be
configured in Days, Hours, and Minutes. Once the input exits the undesired state, the SmartOne will return to
the message interval or time (s) of day for Location Messages.
• Vibration - If Vibration is Enabled, the SmartOne can be configured to send an Undesired State Message
once the device is in a state of vibration or in a state of lacking vibration. The message interval, while selected
undesired state is active, can be configured in Days, Hours, and Minutes.
ACCUMULATE/COUNT MESSAGE
• Input 1/Input 2 - The SmartOne can
accumulate hours and/or count events while
input 1 or input 2 is enabled. The SmartOne
can send an accumulate/count message once
the configurable intervals are specified in days,
hours, and minutes.
• Vibration - If Vibration is Enabled, the SmartOne
can accumulate hours once the device see my
change before in the same Vibration section.
The SmartOne can send an accumulate
message once the configurable intervals are
specified in days, hours, and minutes.
NOTE: SOV = State Of Vibration; SOLV = State Of Leaving Vibration
To Next Page
Loading...
Need help?
General