Page 31SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
REDUCED MESSAGING MODE
CHANGE LOCATION TAB
• Inside Change of Location Area The parameters in this section
define the functionality of the device while inside its Change of
Location Area while in Reduced Messaging Mode.
• Change of Location Range - Specifies the length (in meters,
kilometers, yards, or miles) from the center of the Change of
Location Area.
• Message Interval inside the Change of Location Area - The
SmartOne can be configured to transmit messages while inside
the Change of Location Area. This parameter allows you to
configure the message interval inside the Change of Location
Area in days, hours and minutes. In the Reduced Messaging
Mode, the asset will send infrequent messages if asset is in its
Change of Location Area.
• Position Check Interval while in State of Vibration - The
SmartOne can be configured to check GPS coordinates at a rate
different from the transmission rate. This interval will determine the accuracy in time on how quickly the device
will sense that it has left its Change of Location Area.
To Next Page
Loading...
Need help?
General