Page 37SmartOne C User Manual Confidential & Proprietary Information
9100-0410-01 R2.4
THEFT ALERT MODE
CHANGE LOCATION TAB
• Inside Change of Location Area - The parameters in this section define the functionality of the device while
inside its Change of Location Area while in Reduced Messaging Mode.
• Change of Location Range - Change of Location Range - Specifies
the length (in meters, kilometers, yards, or miles) from the center of
the Change of Location Area.
• Message Interval inside the Change of Location Area - The
SmartOne can be configured to transmit messages while inside the
Change of Location Area. This parameter allows you to configure the
message interval inside the Change of Location Area in days, hours
and minutes. In the Reduced Messaging Mode, the asset will send
infrequent messages if asset is in its Change of Location Area.
• Position Check Interval while in State of Vibration - The SmartOne
can be configured to check GPS coordinates at a rate different from
the transmission rate. This interval will determine the accuracy in
time on how quickly the device will sense that it has left its Change
of Location Area.
To Next Page
Loading...
Need help?
General