- The device is capable of delivering current values exceeding 10mArms.
- Before each use always check the integrity of the device. This is a fundamental
requirement for carrying out the therapy; do not use the device if the buttons or the
cables are defective or malfunctioning.
- It should not be used for purposes other than transcutaneous neurostimulation.
- The device must be used with the transcutaneous neurostimulation electrodes suitable
for this use.
- The device must be kept out of the reach of children.
- With its current, it can disturb ECG monitoring devices.
- It must not be used in a transthoracic mode as it could cause cardiac arrhythmia by
superimposing its frequency to that of the heart. (Do not perform the treatment on the
chest and the back simultaneously)
- A simultaneous connection of a patient to a high frequency electrosurgical device can
cause burns near the electrodes of the stimulator and therefore the stimulator may be
damaged.
- Once you have turned the device on, make sure the display shows the software version
and the device model: it means that the device is working and ready to be used;
If it doesn't, or the display does not show all the segments, turn it off and on again. If the
problem persists, contact the service center and do not use the device.
- The sudden shutdown shortly after the starting indicates a low battery level. Recharge
as reported in the section "HOW TO CHARGE THE BATTERIES".
How to connect the cables
In order to connect the cables to the device, plug the connectors into the intended inlets
on the top of the unit (see picture). Cables should be inserted with grooves downwards.
The inlets are placed exactly under the corresponding channels.
NOTE: for EMS and TENS currents use indifferently the 4 channels with colored cables.
NOTE: For microcurrents and handpiece for face use channel 1 or 3.
NOTE: For ionophoresis, use channel 1 only with gray cables.
To Next Page
Loading...
