TAPE
AUX:
Press this button to return
to
the tape
player when playing the radio. The lighted arrow will
appear and show
the
direction of play when a tape is in
the active mode.
EJECT
Press this button to remove the tape. The radio
will now play. EJECT can be used with either the
ignition or radio off.
To
load
a cassette tape with the
ignition or radio off, press EJECT before loading
the cassette.
CLN:
If this message appears
on
the display,
the
cassette tape player needs
to
be cleaned, It will still play
tapes, but
you
should clean it as soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player”
in
the Index. After you clean
the player, press and hold EJECT for five seconds
to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
CD
Adapter
Kits
It
is possible to use
a
CD
adapter kit with your cassette
tape player after activating the bypass feature on your
tape player.
To
activate the bypass feature, use the following steps:
1.
Turn the ignition
to
RUN
or ACCESSORY.
2.
Turn the radio
off.
3.
Press and hold
the
TAPE
AUX
button
for
five
seconds. The tape symbol on the display will flash
for two seconds, indicating the feature is active.
4.
Insert
the
adapter while the tape symbol is flashing.
It will power up the radio and begin playing.
This override routine will remain active until EJECT
is pressed.
3-19
To Next Page
Loading...
