SCAN:
Press and hold
SEEK
for two seconds
until
SCAN appears
on
the display. SCAN allows
you
to
listen to stations for a few seconds.
The
receiver will
continue
to
scan and momentarily stop at each station
until
you press the button again. The sound will mute
while scanning.
PUSHBUTTONS:
The six numbered pushbuttons let
you
return to your favorite stations. You can set up
to
I8
stations (six AM, six
FM
1
and six
FM2).
Just:
1.
Turn the radio on.
2.
Press AM-FM
to
select the band.
3.
Tune in the desired station.
4.
Press AUTO TONE
to
select the setting you prefer.
5.
Press and hold one
of
the six pushbuttons. The sound
will mute. When
it
returns, release the button.
Whenever
you
press that numbered button, the
station
you
set will return and
the
tone
you
selected
will be automatically selected for that button.
6.
Repeat the steps for each pushbutton.
P.SCAN:
The preset scan button lets
you
scan through
your favorite stations stored on your pushbuttons. Select
either the AM, FMl or FM2 mode and then press
P.SCAN. It will scan through each station stored
on
your pushbuttons and stop for
a
few seconds before
continuing
to
scan through all
of
the
pushbuttons. Press
P.SCAN again or
one
of the pushbuttons
to
stop
scanning to listen
to
a specific stored station. P-SCAN
will
light up on the display while
in
this mode. If one
of
the stations stored
on
a pushbutton is
too
weak for the
location you are
in,
the
radio display will show
the
channel number (PI -P6) for several seconds before
advancing to the next preset station.
Setting
the
Tone
BASS:
Press lightly
on
this knob
to
release
it
from its
stored position. Turn
the
knob to
the
right
to
increase
bass and to the left to decrease bass. When the BASS
control
is
rotated,
the
AUTO
TONE
display
will
go blank.
3-21
To Next Page
Loading...
