A. Blade Assembly
B.
Arm Assembly
C.
Locking Tab
D.
Blade Pivot
E.
Hook Slot
E
Arm Hook
2.
Press down
on
the blade assembly pivot locking tab.
Pull down on the blade assembly to release it from
the wiper arm hook.
3.
Remove the insert from the blade assembly. The
insert has two notches at one end that are locked by
the bottom claws
of
the blade assembly. At the
notched end, pull the insert from
the
blade assembly.
4.
To
install the new wiper insert, slide the
insert
(D),
notched end last, into the end with two blade claws
(A).
Slide the insert all the way through the blade
claws at the opposite end
(B).
The plastic caps
(C)
will be forced
off
as
the
insert is
fully
inserted.
6-39
To Next Page
Loading...
