SECTION VIIC SERVICE PROGRAMMING SYSTEM
2005 Tech 2 User’s Guide VII - 62
11. A Transfer Data screen will appear (Figure VIIC-11). The PC will automatically load the calibration into
the control module.
12. When programming is complete, a Program Controller “Programming Complete” screen appears.
Follow the on-screen instructions (if any), then select Close.
13. Power off the OBPA, then power off the scan tool (wait 30 seconds after OBPA is shut off before
disconnecting the control module in order to allow the controller to reset).
14. Disconnect the OBPA from the Tech 2 and the control module. (Refer to figures VIIC-37 and VIIC-38.)
To Next Page
Loading...