2005 Tech 2 User’s Guide II - 1
SECTION II CARE & CLEANING
Maintenance of the Tech 2 requires periodic inspection and cleaning of:
• The display window
• The keypad
• The cable assemblies and connectors
Make sure the Tech 2 is not connected to a vehicle or other power source and follow the cleaning
procedures detailed below.
Care and Cleaning
After using the Tech 2, a few simple steps will insure that you get the most life out of this diagnostic tool.
NOTICE
Do not spray or pour cleaner anywhere on the Tech 2. If the Tech 2 should become dirty, clean it with a
mild detergent or hand soap. Avoid using harsh solvents such as petroleum-based cleaning agents:
acetone, benzene, trichlorethylene, etc. Harsh solvents can etch Tech 2 plastic surfaces.
Although the Tech 2 is water resistant it is not waterproof, so be sure to thoroughly dry off the Tech 2
prior to usage and/or storage.
Please see next page...
To Next Page
Loading...