SECTION VIIB TIS SOFTWARE
2005 Tech 2 User’s Guide VII - 33
5. Click the “Upload from Handheld” icon on the toolbar (Figure VIIB-15).
• Select Tech 2, then click OK.
• Select Capture Data from upload selection menu, then click OK.
6. The data will display on screen. The top of the screen lists DTCs that were stored in the control module.
The lower portion of the screen lists captured freeze frame or failure record data for the selected DTC.
• Notice that the navigation selections at the bottom of the screen are gray (cannot be selected)
because the data record consists of only one frame.
7. If more than one DTC is present, selecting a DTC in the list changes the data list to match that DTC.
8. Capture Info can be stored and printed by the PC.
9. The user may toggle on/off the DTC(s) at the top of the screen in order to view only the freeze frame or
fail record data by selecting the Show/Hide Failure Record Information icon (Figure VIIB-29) on the
toolbar. This icon is only active for the Capture Info Data function.
Figure VIIB-29
“Show/Hide Failure Record Information” icon selected
To Next Page
Loading...