GME TX6165 - Transmitter Power

TX6165 INSTRUCTION MANUAL
24
To enable Silent Mode on a channel:
1. Select the required channel.
2. Briey press the Menu key followed by pressing and holding the PRI key. The selected code
number will be displayed on that channel.
3. The selected channel will now remain silent unless a signal is received containing the chosen
code.
Note: Silent mode will only be enabled on channels you select. Other channels will remain open to all
incoming signals.
To disable silent mode on a channel:
1. Select the required channel. The CTCSS/DCS code will be displayed.
2. Briey press the Menu key followed by pressing and holding the PRI key. The selected code
number will disappear from the display on that channel. The selected channel will now be
open to all incoming signals.
TRANSMITTER POWER
The transmitter power can be set to High or Low. The power setting option applies to all channels
(except 5/35).
To set the transmit power:
1. Select the required channel.
2. Press and hold the Menu key until the radio beeps.
3. Briey press the Menu key repeatedly until ‘PW’ is displayed. ‘Hi’ or ‘Lo’ will be ashing.
4. Press the or keys to select the required power setting. Select ‘Hi’ for high power or
‘Lo’ for low power.
5. Press the PTT switch to conrm and store your selection.
The radio should now display the selected channel number along with the HI or LO icon to indicate the
transmit power you have set on that channel.