GME TX667 - Battery Charging Procedures; Charging the TX667 Single Unit; Charging the TX667 Twin Pack

TX667 Instruction Manual
14
CHARGING THE BATTERY
The TX667 is powered by a 3.7V 1000mAh Li-ion battery pack. The battery pack
should be fully charged before being used for the rst time to ensure maximum
capacity is available.
CHARGING THE TX667 SINGLE UNIT
The TX667 is supplied with a 240V AC adaptor and a USB lead. The AC adaptor will
charge a fully discharged TX667 battery pack to full capacity in around 2 hours.
To charge the radio:
1. Plug the AC adaptor into a 240V AC outlet.
2. Plug the USB lead into the USB socket on the AC adaptor and the
micro USB connector into the charging socket on the side of the
radio.
While the radio is charging, the indicator LED on the radio will light RED and the
battery icon on the display will animate. Once the battery is fully charged, the
indicator LED will change to green and the battery icon will show the fully charged
state.
CHARGING THE TX667 TWIN PACK
The TX667 Twin Pack is supplied with a twin desktop charger, 240V AC adaptor
and a USB lead. The twin desktop charger with the AC adaptor connected will
charge two fully discharged TX667 battery packs to full capacity in around 3
hours.
To charge the radio:
1. Plug the AC adaptor into a 240V AC outlet.
2. Plug the USB lead into the USB socket on the AC adaptor and the
micro USB connector into the socket on the rear of the desktop
charger.
3. Place the radios into the twin desktop charger.
While the radios are charging, the indicator LEDs on the radios will light red and the
battery icons on the display will animate. Once the batteries are fully charged, the
indicator LEDs will change to green and the battery icons will show the fully charged
state.