2222
Activation required
The LEDs light up blue and two white LEDs move
from the top and bottom to the centre.
The „Access control“/“Charging mode“ is not set
to „Open“. Use a learned RFID chip or the app to
activate the charging process.
Vehicle is not recognised
The LEDs light up blue in the standby mode.
However, the charging process does not start.
Check the charging cable and the tight t of the
plugs.
RFID chip detected
5 LEDs light up green.
The go-e Charger has recognised an RFID chip
authorised for charging and releases the char-
ge.
Unknown RFID chip
5 LEDs light up red.
An unknown RFID chip was used. Use a learned
RFID chip to activate charging.
Internal error
The LEDs ash red.
The go-e Charger has detected a general com-
munication error. Check the error code in the
go-e Charger app.
Grounding fault
The LEDs ash red at the top and glow green/
yellow statically at the bottom.
Check whether the supply line to the go-e Char-
ger is properly grounded.
10. LED status display/troubleshooting
To Next Page
Loading...
