BlueSense Module
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0 Fax: -58080-11
Page 12 / 16
www.go-sys.de info@go-sys.de
5 Procedure after Initial Start
• if applicable sensor calibration (sensor specific)
6 Installation Notes
The BlueSense Module should only be installed by skilled or instructed persons with the suitable tools. In the
case of incorrect assembly serious malfunctions and errors can occur which can destroy the device.
Before connecting the device to electricity it is important to check the power supply network connection data
(voltage and frequency) of your utility provider. This data must correspond. If in doubt, ask your electrician.
Open the BlueSense Module only when the power supply is turned off, never if it is turned on!
Only use the BlueSense Module when the housing is closed, so that no electrical components can be touched.
The electrical safety of the device and optimal RFI protection are only guaranteed if the device is connected to
a properly installed protective conductor system. In case of doubt, call a professional to check the installation.
The manufacturer cannot be held responsible for any damage or malfunctions caused by a missing or broken
ground wire.
During installation the device must not be connected to the power supply mains!
The connection of the device to mains power shall not be via extension cables because these do not guaran-
tee the necessary protection.
7 Maintenance Instructions
The BlueSense Module itself is maintenance free. The sensors, however, should be periodically cleaned and
calibrated. The timeframes for cleaning and calibration depends on the circumstances of the operation and
the used sensors.
To Next Page
Loading...