GO Systemelektronik BlueSense Module - Default Chapter; Table of Contents

BlueSense Module
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0 Fax: -58080-11
Page 3 / 16
www.go-sys.de info@go-sys.de
Table of Contents
1 Overview ................................................................................................................................................................ ................... 4
2 Technical Data and Connection Diagrams................................................................................................ ............................. 5
2.1 Technical Data................................................................................................................................................................ ... 5
2.2 Connection Diagram 1 Control Parameter................................................................................................ ...................... 6
2.3 Connection Diagram 2 Control Parameter................................................................................................ ...................... 7
2.4 Sensor Terminal Connection Diagram............................................................................................................................. 8
2.5 Notes on the Pulse/Digital Inputs................................................................................................................................ ..... 9
2.6 Hazard Note................................................................................................................................................................ ....... 9
3 Commissioning ....................................................................................................................................................................... 10
4 Connection to a BlueBox ........................................................................................................................................................ 11
5 Procedure after Initial Start ................................................................................................................................................... 12
6 Installation Notes ................................................................................................................................................................... 12
7 Maintenance Instructions ...................................................................................................................................................... 12
Appendix A – Calibration Optical Sensors ............................................................................................................................... 13
1 Direct Input of Calibration Coefficients ............................................................................................................................. 13
2 Recalibration ...................................................................................................................................................................... 14
Appendix B – EU Declaration of Conformity ............................................................................................................................ 16
Transportation Note
Avoid exposing the BlueSense Module to ionizing radiation.
Transportation instructions for distributors:
In the case of transnational transport routes and the associated controls, it is possible that
a BlueSense Module is exposed to a too high dose of X-radiation and, as a result, stored
values in the EEPROMs of the sensor plug-in cards may be affected.
Procedure before delivery:
• Switch on BlueSense Module.
• Call up the calibration coefficients with the AMS software.
• Compare the calibration coefficients with the supplied sensor setup protocols and,
if necessary, correction of the calibration coefficients.