Godox AD200Pro - Sync Triggering; Protection Function; Over-Temperature Protection

22
Sync Triggering
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will be fired
synchronously with the camera shutter.
Protection Function
Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire more than 40
continuous flashes in fast succession at 1/1 full power. After 40 continuous
flashes, allow a rest time of at least 10 minutes.
• If you fire more than 40 continuous flashes and then fire more flashes in short
intervals, the inner over-temperature protection function may be activated and
make the recycling time over 10 seconds. If this occurs allow a rest time of about
10 minutes, and the flash unit will the return to normal.
• When the over-temperature protection is started, is shown on the AV display.
Number of flashes that will activate over-temperature protection:
Power Output Level
Number of Flashes
Speedlite flash head
Bare bulb flash head
1/1
40
60
1/2+0.7
50
80
1/2+0.3
60
100
1/2
75
120
1/4(+0.3+0.7)
100
150
1/8(+0.3+0.7)
200
200
1/16(+0.3+0.7)
300
300
1/32(+0.3+0.7)
500
500
1/64(+0.3+0.7)
1000
1000
1/128(+0.3+0.7)
1/256(+0.3+0.7)