Godox AD200Pro - Stable Color Temperature Function; Multi Stroboscopic Flash Mode

15
• The flash duration will only be displayed on the AV pane in M mode.
Stable Color Temperature Function
When use this function, the color temperature changes within ±100K over the entire
power range: enter MENU C.Fn-08 and set it as ON, which means the color temperature
function is turned on. When adjusting the power output from high to low in M mode,
Flash Ready Indicator will blink (the beeper will alarm for 1 minute). Now press the Test
Button to discharge, and the flash can be used as normal.
• This function can only be supported in M non-high-speed mode.
Flash Mode – Multi: Stroboscopic Flash
With stroboscopic flash, a rapid series of flashes is fired. It can be used to capture
multiple images of a moving subject in a single photograph. You can set the firing
frequency (number of flashes per sec. expressed as Hz), the number of flashes, and the
flash output.
Press <MODE> button so that <MULTI> is
displayed.
Turn the Select Dial to choose a desired
flash output.