Godox MF-R76S - Over Temperature Protection; Menu Setting; Other Protections

Note: The light body reset function is unavailable in
menu interface.
Other Protections
Light Body Reset
Long press the focus assist beam button and
MENU button until “RESET” icon appears,
when the “RESET” icon disappears means
reset completed.
Menu Setting
To avoid overheating and deteriorating the flash head, do not fire more than 30 continuous flashes
in fast succession at 1/1 full power. After 30 continuous flashes, allow a rest time of at least 10
minutes.
If you fire more than 30 continuous flashes and then fire more flashes in short intervals, the inner
overtemperature protection function may be activated and < > is shown on the display. If
this occurs, allow a rest time of about 10 minutes, and the flash unit will then return to normal.
Over-Temperature Protection
Number of flashes that will activate
over-temperature protection:
Number of flashes that will activate
over-temperature protection in HSS mode:
First option
WIRELESS
CH
ID
TCM
SYNC
RF DIST
MODEL
STBY
RX STBY
BL
LCD
Secondary option
OFF
TX
RX
01-32
OFF
01-99
OFF
ON
Meaning
Turn off wireless
Turn on transmitter’s wireless
Turn on receiver’s wireless
32 channels
Turn off ID
99 IDs
Off
On（Short press the MODE button can realize TCM transform when
this function is switched on. This function is unavailable in
wireless flash or single port flash.）
First curtain sync
High speed sync
Trigger distance：0.3-10m
Trigger distance：1-100m
Turn on the modeling light, it will not go out when the flash fires.
Turn on the modeling light, it will go out when the flash fires.
Turn on sleep mode when using as a transmitter unit.
Turn off sleep mode when using as a transmitter unit.
Enter sleep mode after 60 minutes of idle use when using as a
receiver unit.
Enter sleep mode after 30 minutes of idle use when using as a
receiver unit.
Turn off sleep mode when using as a receiver unit.
Backlight off over 12 seconds of idle use.
Backlight always off
Backlight always lighting
The contrast ration can be set in7 levels.
CONT
INTER
0.3-10m
1-10 0m
ON
OFF
60 mins
30 mins
OFF
12 secs
OFF
ON
-3~+3
Power Output Level
1/1
1/2
1/4
1/8
1/16
1/32
1/64
1/128
1/256
Number of Flashes
60
80
150
200
340
540
1000
1000
1000
Power Output Level
1/1
1/2
1/4
1/8
1/16
1/32
1/64
Number of Flashes
30
30
35
40
50
50
60
Prompts on the panel
Meaning
A failure occurs on the temperature sensor inside the device, need to be repaired.
A failure occurs on the recycling system so that the flash cannot fire. Please restart
the flash unit. lf the problem still exists, please send this product to a maintenance
center.
The system gets excessive heat. Please allow a rest time of 10 minutes.
The voltage on two outlets of the flash tube is too high. Please send this product to
a maintenance center.
36 37
E0
El
E2
E3
--
RESET