Maintenance
FCC Statement
Warning
Please make sure that whether the flash has finished its recycle or caught up with the
continuous shooting speed or not (the flash ready indicator is lighten) and the flash is not
under the state of over-heat protection or other abnormal situation.
→ Please downgrade the flash power output. If the flash is in TTL mode, please try to change it
to M mode (a preflash is needed in TTL mode).
2.
Whether the distance between the flash trigger and the flash is too close or not (＜0.5m).
→ Please turn on the “close distance wireless mode” on the flash trigger.
→ Please set the MENU- -DIST to 0-30m.
Avoid sudden impacts and the product should be dedusted regularly.
It is normal for the flash tube to be warm when in use. Avoid continuous flashes if unnecessary.
Maintenance of the flash must be performed by our authorized maintenance department which
can provide original accessories.
This product, except consumables e.g. flash tube, is supported with a one-year warranty.
Unauthorized service will void the warranty.
If the product had failures or was wetted, do not use it until it is repaired by professionals.
Changes made to the specifications or designs may not be reflected in this manual.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
3.
Whether the flash trigger and the receiver end equipment are in the low battery states or not
→ Please replace the battery.
4.
Shut down the device immediately should abnormal operation be detected.
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Operating frequency:2412.99MHz – 2464.49MHz
Maximum EIRP Power:4.37dBm
Declaration of Conformity
GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. In accordance with
Article 10(2) and Article 10(10), this product is allowed to be used in all EU member states.For more
information of DoC, Please click this web link:
The device complies with RF specifications when the device used at 0mm from your body.
https://www.godox.com/eu-declaration-of-conformity/
To Next Page
Loading...
