Godox TT600 - Protection Function; Over Temperature Protection

19
4. Press < > button to
return.
bp
Buzz Setting
<ON> On
<OF> Off
1. Press < > button to
enter Custom Functions.
2. Press <SET> button to
enter bp states.
3. Turn the Select Dial
< > to adjust.
4. Press < > button to
return.
bL
Backlight Setting
Backlight can be set
as follows:
<ON> : Always
lighting <12> : Off in
12 sec.
<OF> : Off
1. Press < > button to
enter Custom Functions.
2. Press <SET> button to
enter bL states.
3. Turn the Select Dial
< > to adjust.
4. Press < > button to
return.
OS
Optic Slave Mode
<OF> Off
<S1> S1 mode
<S2> S2 mode
1. Press < > button to
enter Custom Functions.
2. Press <SET> button to
enter OS states.
3. Turn the Select Dial
< > to adjust.
4. Press < > button to
return.
Protection Function
Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire more than 30
continuous flashes in fast succession at 1/1 full power. After 30 continuous
flashes, allow a rest time at least 10 minutes.
• If you fire more than 30 continuous flashes and then fire mode flashes in short
intervals, the inner over-temperature protection function may be activated and
make the recycling time about 10 to 15 seconds. If this occurs, allow a rest time
of about 10 minutes, and the flash unit will then return to normal.
• When the over-temperature protection is started, is shown on the LCD
display.