16
Wireless Flash Shooting: Ratio (2.4G) Transmission
• TT600 has 2.4G ratio transmission (Master/Slave)
• Wireless mode setting: Long press < > button and hold for 2 seconds until
< > icon is blinking. Turn the Select Dial to set from OFF/Master(M)/Slave(S)
mode.
• Channel setting: Long press < > button and hold for 2 seconds until the figure
besides the CH is blinking. Turn the Select Dial to choose the channel from 1~32.
• Group setting: Short press < > button to select group. In master mode, groups
can be selected from M/A/B/C/D/E, while in Slave mode, groups can be selected
from A/B/C/D/E.
• As TT600S adopts Godox wireless X system, it is compatible with AD3600II-C,
AD360II-N, TT685C, TT685N, X1T-C, X1T-N, X1T-S wireless control, etc.
• See the picture below:
Wireless Control Function
• The flash unit is built in with a Wireless Control Port (6) so that you can wirelessly
adjust the power level of the flash and control the on-or-off of your flash, focus
assist beam and buzzer as well as trigger the flash.
• To control the flash wirelessly, you need a Godox FT series remote control set
(on-camera and on-flash).
Insert its receive end into the Wireless Control Port (6) on the flash and insert the
transmit end into the camera hot shoe. Settings made on the hotshoe-mounted
transmit and receive ends will be wirelessly communicated to the flash. Then you
can press the camera shutter-release button to trigger the flash. You can also
hold the transmit end at hand to control your off-camera flash.
To Next Page
Loading...
