7
Battery
AA alkaline batteries are recommended.
Installing Batterie
As shown in the illustration, slide the battery compartment lid of the flash trigger and
insert two AA batteries separately.
Battery Indication
Check the battery level indication on the LCD panel to see the remaining battery level
during the usage.
Low battery, please replace it.
<2.5V The battery level is going to be used
out immediately (please replace new
batteries, as low power lead to no flash or
flash missing in case of long distance).
The battery indication only refers to AA alkaline batteries. As the voltage of Ni-MH
battery tends to be low, please do not refer to this chart.
Setting the Flash Trigger
Power Switch
Slide the Power Switch to ON, and the device is on and status indicator lamp will not
reveal.
Note: In order to avoid power consumption, turn off the transmitter when not in use.
To Next Page
Loading...
