18
• Full match and back to APP main interface.
• When started the Bluetooth function, the Bluetooth icon will be displayed on the
transmitter’s panel.
• Set the channels of the slave flash and the transmitter to the same, and
parameter e.g. slave flash mode, power value, modeling lamp and beep can be
controlled on the APP of the smartphone.
• Use the APP of the smartphone for shooting after setting all the parameter.
Note: When successfully connected the flash trigger and smartphone APP, the auto
sleep of the flash trigger can be set to 30 min.
Compatible Smartphone Models
This flash trigger can be used on the following Smartphone models:
• This table only lists tested Smartphone models, not all Smartphone. For the
compatibility of other Smartphone models, a self-test is recommended.
• Rights to modify this table are retained.
To Next Page
Loading...
