Godox X2T-C - Using the Flash Trigger; As a Wireless Camera Flash Trigger

13
1/128(0.1)
The minimum output is
1/128(change in 0.1 step)
1/256(0.1)
The minimum output is
1/256(change in 0.1 step)
3.0(0.1)
The minimum output is
3.0(change in 0.1 step)
2.0(0.1)
The minimum output is
2.0(change in 0.1 step)
GROUP
Group
5 (A-E)
5 groups (A/B/C/D/E)
3 (A-C)
3 groups (A/B/C)
STBY
Sleep
60sec
60 seconds
30min
30 minutes
60min
60 minutes
OFF
--
LIGHT
Backlighting time
12sec
Auto off in 12 seconds
OFF
Always off
ON
Always lighting
LCD
Contrast ration
of LCD panel
-3-+3
The contrast ratio can be set as
integral number from -3 to +3
Using the Flash Trigger
Ass a Wireless Camera Flash Trigger
Take TT685C as an example:
• Turn off the camera and mount the transmitter on camera hotshoe. Then, power
on the flash trigger and the camera.
• Short press the <MENU> button to set channel, group, mode and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Turn on the camera flash, press the < > wireless setting button and the < >
wireless icon and <SLAVE> slave unit icon will be displayed on the LCD panel.
Press the <CH> button to set the same channel to the flash trigger, and press the
<Gr> button to set the same group to the flash trigger. (Note: please refer to the
relevant instruction manual when setting the camera flashes of other models).
• Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.