Godox X2T-C - As a Wireless Outdoor Flash Trigger; As a Wireless Original Flash Trigger

14
As a Wireless Outdoor Flash Trigger
Take AD600B as an example.
• Turn off the camera and mount the transmitter on camera hot shoe. Then, power
on the flash trigger and the camera.
• Short press the <MENU> button to set channel, group, mode and parameter
(refers to the contents of “Setting the Flash Trigger”).
• Power on the outdoor flash and press the < > wireless setting button and the
< > wireless icon will be displayed on the LCD panel. Long press the <GR/CH>
button to set the same channel to the flash trigger, and short press the <GR/CH>
button to set the same group to the flash trigger (Note: please refer to the
relevant instruction manual when setting the outdoor flashes of other models).
• Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.
As a Wireless Original Flash Trigger
Take 600EX RT as an example:
• Turn off the camera and mount the transmitter on camera hot shoe. Then, power
on the flash trigger and the camera.
• Short press the <MENU> button to set channel, group, mode and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Attach the original flash to the X1R-C receiver. Press the <CH> button on the
receiver to set the same channel to the flash the trigger and press the <Gr>
button to set the same group to the flash trigger (Note: please refer to the
relevant instruction manual when setting the original camera flashes).
• Press the camera shutter to trigger. And the status lamp of the camera flash and
the flash trigger both turn red synchronously.