GOEBEL GO-RN2 - Riveting in Conventional Riveting Mode; Riveting in Fully Automatic Riveting Mode; Setting the Riveting Mode

Deutsch | 2 English | 14
3.3 Setting the riveting mode (Important note before setting the riveting mode)
Before switching the riveting mode, please refer to the specications and material
properties of the blind rivet nut, as well as other information about the capacity and
riveting condition to select the appropriate riveting mode. There are two riveting
modes: the fully automatic riveting mode and the conventional riveting mode.
3.4 Riveting in fully automatic riveting mode (with flashing green light)
The fully automatic riveting mode is possible by the "ashing green light" ➁ in riveting
mode (L) and (H). It is recommended to use the fully automatic riveting mode only with
semi-hex and full hexagonal shank blind rivet nuts. The blind rivet nut has previously
been inserted into the work piece (hole) and the mandrel is automatically screwed into
the blind rivet nut (threading). Then, it automatically pulls the blind rivet nut (deforma-
tion) (without actuating the trigger) and spindles off automatically. The fully automatic
riveting mode is suitable for assembly line work and signicantly increases capacity.
3.5 Riveting in conventional riveting mode (with green light)
The conventional riveting mode is possible by the "always green light" ➁ in riveting
mode (L) and (H). It is recommended to use the conventional riveting mode with round
shank blind rivet nuts. In the conventional riveting mode, the blind rivet nut is
automatically threaded onto the mandrel, lead is applied to the mandrel, the blind rivet
nut is inserted into the hole on the work piece, the trigger is actuated and the blind rivet
nut deforms. Finally, the blind rivet nut automatically spindles off the mandrel.
Special note, the fully automatic riveting mode is only suitable for assembly line
operation, in combination with semi or full hexagonal blind rivet nuts. For round shank
blind rivet nuts we recommend the conventional riveting mode.
Function display panel
To switch to fully automatic riveting mode, press the key ➂
button for 3 seconds and the green light ashes!
To switch to conventional riveting mode, the key ➂ must be pressed for 3 seconds and
the green light will no longer ash. A solid green light tells you that the tool is back in
conventional riveting mode.
www.goebelfasteners.com