GOEBEL GO-RN2 - 5. Charger & Battery

Deutsch | 2 English | 18
5. Charger & Battery
5.1 Technical parameters
Charger
Output: 18V - 2.0Ah
Input: 100 - 240V /50 - 60HZ/ 1 A
Net weight: 9.5oz
5.2 Charger usage
The charger is connected to the power supply, the green indicator light ➀ is always on,
works properly and charges the battery in the direction of the arrow.
Operation Charge control
light (1)
Symbols (2)
Explanation
Measures
Battery
charged in
charger
▶
Red light on
▶
The battery is in good
condition. The charging
time is about one hour.
▶
In good condition
▶
Green light on
▶
Battery malfunction.
Cannot be charged.
▶
Immediately disconnect the
power supply, remove the battery
and replace it with a new battery.
The battery is
charged
▶
Green light on
▶
The battery is full. Please
remove the battery.
▶
In good condition
▶
Red light on
▶
When the internal
temperature rises, the
charger stops working.
▶
Immediately disconnect the
power supply, remove the battery
and replace it with a new battery.
Battery
Output: 18V - 2.0Ah - 36Wh
Net weight: 13oz
12
5.3 Battery usage
• During use, please check (see P9 Battery check) the battery power.
• The battery has deep discharge protection (ECP) and can be recharged about 1000 times.
• Do not use the charger until the battery has cooled down sufciently.
• If the battery's operating time is signicantly reduced during normal use, this indicates
that the battery should be replaced.
➀
Charge indicator light
➁ Loading symbols
www.goebelfasteners.com