GOK SmartBox 4

To Next Page

To Previous Page

SmartBox

4 / SmartBox

4 PRO

part no. 28 400 57 d 5 / 28

Damaged or destroyed insulation!

Can result in short circuit or electric shock.

Do not use the device if the insulation is damaged!

Have new insulation installed by a specialised company!

Selecting an installation location / Checking the reception quality of the mobile phone

network

Before installing the SmartBox

, you must check whether the reception quality of the

applicable telecommunications network is sufficient. The easiest way to do this is to have a

mobile phone ready at the designated place of installation. As a precondition, the mobile

phone must be registered with the same telecommunications network (in Germany e. g. T-

Mobile, Vodafone, O

) as the SIM card which is used for the SmartBox

If there is no suitable mobile phone at hand, you can also perform the test with the SIM card

for the SmartBox

. In this case, insert this activated SIM card into a mobile phone and switch

it on again.

The reception quality at the designated place of installation can simply be seen from the

indication in the mobile phone screen. At least one bar/scale line of the reception quality

indicator must be visible on the screen. If the reception quality is very bad (no bar/scale line

visible), another installation site should be picked and tested (possibly in another room).

If the reception quality is very bad, an additional antenna (accessory) should be used. It can

be installed e. g. in front of a basement window.

Installation of the display unit

Mount the display unit to the wall in a suitable position.

1. Open the display unit by removing the bottom cover.

2. After loosening the 2 screws, open the display unit by removing the cover.

3. Mount the display unit to a smooth vertical wall by means of dowels by the four fixing

holes with the enclosed screws and anchors. Take care not to damage the housing.

4. After connecting the terminals and setting the unit up, replace the covers.

Installing the level probe

See assembly and operating instruction “Level probe“.

GOK SmartBox 4 - Page 5