Golden Eagle Talon - Fuel and Heat Level Adjustment


LOWFEEDADJUSTMENT

TheLowFeedAdjustmentbuttonisanoptionalfuelfeedcontrolthatmostpeoplewillneverneedto
use.TheLowFeedAdjustmentbuttonwillslightlychangethefeedrateofthenumberoneheatlevel
setting.Ithasnoaffectonanyoftheotherheatlevels.

Differentsize
andqualitypelletfuelmayrequireadjustmentofthe“1”feedsettingontheHeatLevel
Advancebargraph.Thisisusuallyaone‐timeadjustmentbasedonthefuelyouareusing.The“LOW
FEEDADJUSTMENT”buttonwhenadjustedwillallowfor3differentfeedratesettingsforthe
#1feed
settingonly.Toadjustsimplypushthe“LOWFEEDADJUSTMENT”buttonwhilethestoveis
operatingatsetting“1”andwatchthebargraph.

 Whenthe“1”&“3”lightsareilluminatedonthebargraphthelowfeedrateisatits“lowest”
setting.
 Whenthe“1”lightisilluminatedonthebargraphthelowfeedrateisatits“normal”setting.
 Whenthe“1”&“4”lightsareilluminatedonthebargraphthelowfeedrateisatits“highest”
setting.

YoushouldonlyusetheLowFeedAdjustmentbuttonunderlimitedcircumstances.Ifyouareunable
tokeepafiregoingonthenumberoneheatlevelsettingwiththedampercompletelyclosedthen
youshouldusetheLowFeedAdjustmentbuttonsothatwhentheunitisonthenumberoneheat
levelsettingthe#1and#4lightsareon.Thiswillfeedjustalittlebitmorefueltothefire.You
shouldalsodothisifyouareusingtheunitwithathermostatintheHigh/Lowthermostatmode.

TheLowFeedAdjustmentbuttononlychangesthefuelfeedrateforthe#1setting.Ithas
noeffectontheotherheatlevelsettings.

Whenthestoveisseton“1”the“LowFeedAdjustment”valueswillbeshownontheHeat
LevelAdvancebargraph.ForexampleiftheLowFeedAdjustmentissettoitslowest
settingeverytimethestoveissettolowthe“1”and“3”lightswillbeilluminatedonthe
bargraph.

WhenusingthestoveintheHigh/Lowthermostatmodewerecommendthatyouusethe
LowFeedAdjustmentbuttonsothatthe#1and#4lightsaredisplayedwhenonthelowest
setting.


HEATLEVELADVANCE

 Thisbuttonwhenpushedwillsetthepelletfeedrate,hencetheheatoutputofyourstove.The
levelsofheatoutputwillincrementallychangeonthebargraphstartingfromlevel“1”to“5”.

WHENDROPPING3ORMOREHEATLEVELSETTINGS(4TO1,OR5TO2OR1)PUSHTHE
‘HIGHFAN’BUTTONANDALLOWTHEROOMAIRFANTORUNATTHATSETTINGFORAT
LEAST5MINUTESTOPREVENTTHESTOVEFROMTRIPPINGTHEHIGHTEMP
THERMODISK.