Golden Eagle Talon - User Manual

Questions and Answers

W
Wendy GarciaOct 25, 2025
Why does my Golden Eagle Talon shut off and the #2 light flash?
- C
  Carolyn ReedOct 25, 2025
  Your Golden Eagle Pellet stove might shut off and display a flashing #2 light due to several reasons: * A blocked airflow switch hose or stove attachment pipes: Unhook the air hose from the air switch and blow through it to check for blockages. Clear any obstructions with a wire coat hanger if necessary. * Blockage in the air inlet, burnpot, combustion air chambers, combustion blower, or exhaust pipe: Follow the cleaning procedures in the maintenance section. * Improperly sealed firebox: Ensure the door is closed tightly and the gasket is in good condition. Also, check the ash door and slider plate (if applicable) for proper sealing. * Incorrectly installed vent pipe: Verify that the vent pipe installation meets the guidelines in the owner's manual. * Faulty airflow switch wire ...
R
ramirezalanNov 4, 2025
What to do if my Golden Eagle Talon Pellet stove shuts off and the #2 light flashes?
- K
  Kenneth GlennNov 5, 2025
  If your Golden Eagle Pellet stove shuts off and the #2 light flashes, it indicates a problem with airflow or other components. Here's what you can do: 1. Check the airflow switch hose and attachment pipes for blockages. Disconnect the hose and blow through it. If blocked, use a wire coat hanger to clear it. 2. Inspect the air inlet, burnpot, combustion air chambers, combustion blower, and exhaust pipe for ash or foreign material. Clean as necessary. 3. Ensure the firebox is properly sealed. Check the door and gasket, ash door latch (if applicable), and slider plate. 4. Verify that the vent pipe is installed correctly, according to the owner's manual. 5. Examine the airflow switch wire connections for any issues. 6. Check the gray wires at the Molex connector to ensure they are not l...
L
lesliebrooksNov 14, 2025
How to troubleshoot a Golden Eagle Talon that shuts off with a flashing #2 light?
- J
  jeffreywhiteNov 14, 2025
  To troubleshoot a Golden Eagle Pellet stove shutting off with a flashing #2 light, consider these potential causes and solutions: * **Blocked Airflow:** Check the airflow switch hose and ensure it's free of obstructions. Blow through it; if blocked, clear with a wire. * **Dirty Components:** Inspect the air inlet, burnpot, combustion air chambers, combustion blower, and exhaust pipe for ash buildup. Clean as needed. * **Poor Seal:** Verify the firebox is properly sealed. Ensure the door and gasket are in good condition, and the ash door and slider plate (if applicable) are secure. * **Vent Issues:** Confirm the vent pipe installation adheres to the owner's manual guidelines. * **Wiring Problems:** Check the airflow switch wire connections and the gray wires at the Molex connecto...