11
ADVANCED PROGRAMMING (MONITOR FUNCTIONS)
To activate doctor mode: Press button , and the programming LED will indicate with 2
blinks that the function is activated or with 1 blink that the function is deactivated.
Advanced programming enables the monitor's default settings to be changed
:
Switch off the monitor to be programmed.
Once switched off, press button for 3 seconds to enter of" "Menu 1
advanced programming, and the programming LED will illuminate
.
Adjusting the call volume: Press button to select the required volume. (Options:
minimum, medium and maximum). Regardless of the volume set, the apartment“
front door call ringtone will always sound at the highest level.”
Then adjust the settings as required:
- Adjusting the call volume: High volume (default setting).
Select the ringtone to be changed: Each press on button selects a ringtone which is
indicated with blinks (1 to 4 blinks) of the programming LED and in the following order: door
panel, guard unit, intercom call and HZ apartment front door call. When the final selection“ ”
is reached, the following press returns the user to the first selection and 1 blink of the
programming LED (carousel mode).
- :Changing the ringtone melody
Then select the melody for the ringtone (selected in the previous step) by pressing
“ ”button until the required carousel mode melody is heard.
The monitor has different ringtones to identify the origin of the call. The melodies assigned by default to the
ringtones can be selected from among others available on the monitor
.
- .Activating / deactivating the doctor mode function: Doctor mode not activated (default setting)
The doctor mode function enables the door release to be activated automatically 6 seconds after making a call“ ”
from the door panel without having to establish communication or press door release button . The call ends
after 20 seconds and the channel is freed.
(Only the master monitor should be configured with doctor mode ).“ ”
Men 1:u
Advanced programming of the functions of the Tekna Plus SE monitor:
TEKNA PLUS SE MONITOR
Continued overleaf
- Accessing Menu 2 or exiting programming mode:" "
To access , press button , and the programming LED will blink twice." "Menu 2
To exit programming mode, press button for 3 seconds, and the programming LED will turn
off (see page 14).
To Next Page
Loading...
