golmar Tekna Plus SE - Advanced Programming Menu 4

14
ADVANCED PROGRAMMING (MONITOR FUNCTIONS)
TEKNA PLUS SE MONITOR
Continued from the previous page.
Men 4:u
Then adjust the settings as required:
No function.
- .Button has no function
No function.
- .Button has no function
No function.
- .Button has no function
- Accessing Menu 1 or exiting programming mode" " :
To access Menu 1 , press button , and the programming LED will blink once (see page 11)." "
To exit programming mode, press button for 3 seconds, and the programming LED will
turn off.
When exiting advanced programming mode, the monitor will turn off: Press button for 3
seconds to turn the monitor back on. After any resetting of the monitor and for the following
45 seconds, no operation with it can be performed.
- Turning on the monitor when exiting programming:
- D setting ," efault " a :ll the advanced monitor programming options
Set to "default setting": Press button , the will indicate with acoustic tones that alland monitor 2
the options of the advanced programming of the monitor are with its default(pag. 11-14) setting.
(With monitor V03 and later).